Section 4 Preparations for Debugging
3.6
Connecting the Emulator to the User System
Use the procedure below to connect the emulator to the user system with the user system interface
cable, or to disconnect them when moving the emulator or the user system.
1. Check that the host computer is turned off or the emulator is not connected to the host
computer with the USB cable.
2. Connect the user system interface cable to the user-side connector of the emulator.
3. Connect the USB cable to the host-side connector of the emulator.
Figure 3.8 shows the position of the connector.
User interface cable connector
Figure 3.8 Position of the Connector
Rev. 1.00 Nov. 26, 2007 Page 28 of 230
REJ10J1766-0100