Advertisement
Section 6 Tutorial
Note: The items that can be set in this dialog box differ according to the product. For details on
the settings for each product, refer to the online help.
Run the program as shown in the example of section 6.18, Hardware Break Function. The trace
results are displayed in the [Trace] window after the program execution is completed.
• If necessary, adjust the column widths by dragging borders in the header bar (immediately
below the title bar).
Note: The type and the amount of information that can be acquired by a trace differ according to
the product. For details on the specifications of each product, refer to the online help.
6.19.3
AUD Trace Function
This function is available when the AUD pin of the MPU is connected to the emulator.
The following is the procedure for setting the AUD trace function.
(1) Setting the trace acquisition mode
Display the [Trace] window.
Click the [Trace] window with the right-hand mouse button and select [Acquisition] from the
popup menu to display the [Trace Acquisition] dialog box.
Select [AUD function] as the [Trace type].
The trace acquisition condition is set in the [Trace mode] page.
Rev. 1.00 Nov. 26, 2007 Page 192 of 230
REJ10J1766-0100
Figure 6.45 [Trace] Window
Advertisement
Troubleshooting
