6.15.3
Executing [Step Over] Command
The [Step Over] command executes a function call as a single step and stops at the next statement
of the main program.
• Move to the change function following the procedures described in section 6.15.1, Executing
[Step In] Command.
• To step through all statements in the change function at a single step, select [Step Over] from
the [Debug] menu of the High-performance Embedded Workshop for CPU1, or click the [Step
Over] button on the toolbar. After that, select [Go] from the [Debug] menu in the High-
performance Embedded Workshop for CPU0, or click on the [Go] button on the toolbar.
Figure 6.27 [Step Over] Button
Rev. 1.00 Nov. 26, 2007 Page 173 of 230
Section 6 Tutorial
REJ10J1766-0100