Advertisement
Section 2 Emulator Functions
This function is hereafter called the performance measurement function or PA1.
Note: Items to be measured differ according to the product and some products do not support
this function. For details on the specifications of each product, refer to the online help.
2.5
Memory Access Functions
The emulator has the following memory access functions.
(1) Memory read/write function
[Memory] window: The memory contents are displayed in the window. Only the amount
me command:
(2) User program downloading function
A load module registered in the workspace can be downloaded. Such module can be selected
from [Download Module] in the [Debug] menu. Downloading is also possible by a popup menu
that is opened by right-clicking on the mouse at the load module in the workspace. The user
program is downloaded to the RAM or internal flash memory.
When downloading to the flash memory that has not been within the MPU, select [Emulator] from
the [Setup] menu, open the [Configuration] window, and perform required settings on the
[Loading flash memory] page.
This function also downloads information required for source-level debugging such as debugging
information.
(3) Memory data uploading function
The specified amount of memory from the specified address can be saved in a file.
(4) Memory data downloading function
The memory contents saved in a file can be downloaded. Select [Load] from the popup menu in
the [Memory] window.
Rev. 1.00 Nov. 26, 2007 Page 16 of 230
REJ10J1766-0100
specified when the [Memory] window is opened can be read. Since there is
no cache in the emulator, read cycles are always generated. If the memory is
written in the [Memory] window, read cycles in the range displayed in the
[Memory] window will occur for updating the window. When the [Memory]
window is not to be updated, change the setting in [Lock Refresh] from the
popup menu.
A command line function that reads or writes the specified amount of
memory at the specified address.
Advertisement
Troubleshooting
