Section 4 Preparations for Debugging
Figure 3.20 Dialog Box to Confirm Updating of the SHxxxx Emulator Firmware
The USB cable must not be disconnected until writing is
complete.
Early disconnection may damage the emulator.
9. The dialog box shown in figure 3.21 is displayed.
Figure 3.21 Dialog Box of the RESET Signal Input Request Message
10. Power on the user system.
11. Input the reset signal from the user system, and click the [OK] button.
12. If no reset signal is detected, the following dialog box is displayed.
Rev. 1.00 Nov. 26, 2007 Page 42 of 230
REJ10J1766-0100
CAUTION