Advertisement
When [AUD function] has been selected
[AUD mode1]
: Selection of realtime or non-realtime trace acquisition
[Realtime trace]
[Non realtime trace]
[AUD mode2]
: Specify the operation when the trace buffer is completely full.
[Trace continue]
[Trace stop]
[AUD trace
: Specify the range for which AUD trace information will be displayed.
display range]
[Start pointer]
[End pointer]
⎯ Common to [I-Trace]/ [AUD function]
[Display Type]
Specify the information to be displayed in the trace window.
[CPU0]
[CPU1]
: When a next branch is encountered while
trace can be replaced by the latest trace
information to be acquired. Thus, while the
user program is executed in realtime, the
acquisition of some trace information
might not be possible.
: When a next branch is encountered while
trace information is being acquired, CPU
operation is suspended until acquisition of
the trace information is completed. The
user program is thus not executed in
realtime.
: Continue trace acquisition. The earliest
trace information will be overwritten.
: Once the trace buffer is full, trace
information is not acquired.
: Set the pointer to the start of the range for
AUD tracing.
: Set the pointer to the end of the range for
AUD tracing.
: Display the trace information for which
the CPU identifier (CPU ID) is CPU0.
: Display the trace information for which
Rev. 1.00 Nov. 26, 2007 Page 119 of 230
Section 5 Debugging
REJ10J1766-0100
Advertisement
Troubleshooting
