Advertisement
Section 5 Debugging
When [Value] is selected, if an overloaded function or class name including a member function is
specified in address, the [Select Function] dialog box opens.
Clicking the [OK] button sets the break conditions. Clicking the [Cancel] button closes this dialog
box without setting the break conditions.
5.5.13
Setting Break Conditions
On the [Event condition] sheet, the settings for break conditions are displayed, modified, and
added.
Figure 5.16 [Event] Window ([Event condition] Sheet)
This window displays and sets the break condition. Since the number of channels for detecting
conditions and the contents to be set differ depending on the product, refer to the on-line help for
each product.
Items that can be displayed in the sheet are listed below.
[Type]
Break channel number
[State]
Whether the breakpoint is enabled or disabled
Enable: Valid
Disable: Invalid
[Condition] A condition that satisfies a break. The displayed contents differ depending on the
break type.
[Action]
Operation of the emulator when a break condition is satisfied.
Break: Breaks program execution
Rev. 1.00 Nov. 26, 2007 Page 104 of 230
REJ10J1766-0100
Advertisement
Troubleshooting
