Advertisement
(1) The connector must be installed to the user system. Table 3.2 shows the recommended
connector for the emulator.
Table 3.2 Recommended H-UDI Port Connector
Connector
Type Number
14-pin connector
2514-6002
36-pin connector
DX10M-36S
DX10M-36SE,
DX10GM-36SE
Notes: 1. When designing the 14-pin connector layout on the user board, do not place any
components within 3 mm of the H-UDI port connector.
When designing the 36-pin connector layout on the user board, do not connect other
signal lines to the H-UDI port connector.
2. The H-UDI is an interface compatible with the Joint Test Action Group (JTAG)
specifications.
(2) The pin assignments of the connector are shown in section 2 in the additional document,
Supplementary Information on Using the SHxxxx.
(3) Connect pins 5 and GND bus read located in the center of the H-UDI port connector (when
using the 38-pin user system interface cable) and pins 9, 10, 12, 13, and 14 (when using the 14-
pin user system interface cable) of the H-UDI port connector to GND firmly on the PCB.
These pins are used as electrical GND and to monitor the connection of the H-UDI port
connector. Note the pin assignments of the H-UDI port connector.
Manufacturer
Minnesota Mining &
Manufacturing Ltd.
Hirose Electric Co., Ltd.
Section 3 Preparation before Use
Specifications
14-pin straight type
Screw type
Lock-pin type
Rev. 1.00 Nov. 26, 2007 Page 29 of 230
REJ10J1766-0100
Advertisement
Troubleshooting
