Advertisement
Section 5 Debugging
Figure 5.41 [Driver Details] Dialog Box (2)
Information displayed in figure 5.41 is the information of the USB connector to which the
emulators are connected.
Note: The displayed character strings of the information differ according to the host computer's
environment.
Check which of the character strings of information show emulators.
Select [<no driver selected>] in the [Driver] drop-down list box and disconnect one emulator from
the USB connector. After that, select [Renesas E-Series USB Driver] in the [Driver] drop-down
list box. Only information on the USB connector that the emulator is connected to is displayed in
the [Channel] drop-down list box.
The above procedures are used to discern which of the emulators are indicated by the displayed
character strings of information in the [Channel] drop-down list box.
When initiating the High-performance Embedded Workshop, in the [Channel] drop-down list box,
select the information on the USB connector of the emulator that is connected to the master CPU.
Initiate the High-performance Embedded Workshop using the normal procedures.
When initiating the slave High-performance Embedded Workshop, in the [Channel] drop-down
list box, select the information on the USB connector of the emulator that is connected to the slave
CPU.
Rev. 1.00 Nov. 26, 2007 Page 146 of 230
REJ10J1766-0100
Advertisement
Troubleshooting
