Advertisement
Section 6 Tutorial
The PC breakpoint that has been set is displayed in the [Event] window.
Figure 6.33 [Event] Window (PC Breakpoint Setting)
Note: The items that can be displayed in this window differ according to the product. For the
items that can be displayed, refer to the online help.
To stop the tutorial program at the PC breakpoint, the following procedure must be executed:
• Set the program counter and stack pointer values (PC = H'00000800 and R15 = H'FFF90000)
that were set in section 6.8, Setting Registers, in the [Register] window of the High-
performance Embedded Workshops for CPU0 and CPU1. Click the [Go] button in the High-
performance Embedded Workshops for CPU0 and CPU1.
The internal RAM area differs depending on the MCU. Refer to the hardware manual of the
MCU used.
• If program execution is failed, reset the device and execute again the procedures above.
Rev. 1.00 Nov. 26, 2007 Page 178 of 230
REJ10J1766-0100
Advertisement
Troubleshooting
