Advertisement
Note that the pin number assignments of the connector
differ from those of the connector manufacturer.
Notes:
1.
Connection of the signals differs depending on the package. For details, refer to the
MPU's pin assignments.
2.
The range of communication that the emulator operates at is different depending on
the MPU used.
3.
To connect the signals from the connector, refer to section 1 in the additional
document, Supplementary Information on Using the SHxxxx.
4.
When developing user systems, do not connect the TDI and TDO signals of the
device to the boundary scan loop, or separate them by using a switch (figure 3.11).
CAUTION
Section 3 Preparation before Use
Rev. 1.00 Nov. 26, 2007 Page 31 of 230
REJ10J1766-0100
Advertisement
Troubleshooting
