Renesas HS0005KCU04HE User Manual page 203

• Click the [OK] button.
• The first point display in the State line changes from Disable to Enable.
• The first point display in the Condition line changes from None to Address =
H'00101050 (tutorial.cpp/45) pc Core Select: CPU1 Break (CPU1).
• Set the program counter and stack pointer values (PC = H'00000800 and R15 = H'FFF90000)
that were set in section 6.8, Setting Registers, in the [Register] window of the High-
performance Embedded Workshops for CPU0 and CPU1. Click on the [Go] buttons of both
High-performance Embedded Workshops.
The internal RAM area differs depending on the MCU. Refer to the hardware manual of the
MCU used.
• If program execution is failed, reset the device and execute again the procedures above.
The program runs and then stops at the condition specified under Ch1 (IA_OA_DT_CT).
Rev. 1.00 Nov. 26, 2007 Page 183 of 230
Section 6 Tutorial
REJ10J1766-0100