Advertisement
This dialog box is used to specify conditions for the acquisition of trace information.
When [I-Trace] has been selected:
[I-Trace mode]:
[Channel 1]
: Set the trace acquisition conditions for channel 1. The same conditions
cannot be set for channels 1 and 2.
[Type]
[M-Bus & Branch, CPU0]
[I-Bus, CPU0]
[F-Bus, CPU0]
[M-Bus & Branch, CPU1]
[I-Bus, CPU1]
[F-Bus, CPU1]
[DMAC]
[Channel 2]
: Set the trace acquisition conditions for channel 2. The same conditions
cannot be set for channels 1 and 2.
[Type]
[M-Bus & Branch, CPU0]
Set the bus and other conditions for acquisition of the internal trace.
: Trace information is acquired with M-bus
access and branching by CPU0 as
conditions.
: Trace information is acquired with I-bus
access by CPU0 as condition.
: Trace information is acquired with F-bus
access by CPU0 as a condition.
: Trace information is acquired with M-bus
access and branching by CPU1 as
conditions.
: Trace information is acquired with I-bus
access by CPU1 as a condition.
: Trace information is acquired with F-bus
access by CPU1 as a condition.
: Acquires trace information on access by
the DMAC.
: Trace information is acquired with M-bus
access and branching by CPU0 as
conditions.
Rev. 1.00 Nov. 26, 2007 Page 115 of 230
Section 5 Debugging
REJ10J1766-0100
Advertisement
Troubleshooting
