Mechanical Backhoe Bucket Quick Coupler - New Holland B95CTC Operator's Manual

Mechanical backhoe bucket quick coupler

WARNING
Crushing hazard!
Never put your hands inside the quick coupler
when the engine is running. Turn off the en-
gine and wait for all movement to stop.
Failure to comply could result in death or se-
rious injury.
It is possible to install a mechanical quick coupler (1) on
the dipper using the standard pins.
Make sure the tool to be installed is in a safe area on hard,
level ground with its pins in place.
Make sure the tool linkage pin is in maximum force (2)
position.
NOTICE: It is imperative for the linkage pin to be in max-
imum force position, otherwise the quick coupler will not
engage.
Make sure the quick coupler jaw is open.
Use the bucket and dipper controls to engage the quick
coupler hook round the lower pin.
Use the bucket controls to engage and lock the pin (3)
completely in the quick coupler jaw.
Stop the engine and remove the starter switch key.
Install the quick coupler safety pin.
ATTENTION: Make sure the safety pin is correctly in-
stalled in the quick coupler as described in the manufac-
turer's instructions after each tool change. In the event
of any doubt concerning the safety pin or adjustments, do
not hesitate to consult your Dealer.
To change the tool, release the jaw (with the safety pin
removed) using the lever (4) supplied for opening it.
10 - ACCESSORIES
W0252A
10 - 2
1
LEEN12T0680BA