Backhoe Attachment Hydraulic Controls - New Holland B95CTC Operator's Manual

Backhoe attachment hydraulic controls

1. Control enable switch: with this switch in the ON
(lamp on) position, all backhoe attachment hy-
draulic controls are functional.
2. Left-hand hydraulic control lever: The left-hand hy-
draulic control lever controls attachment swing and
the boom or the dipper (depending on the control
pattern adopted).
3. Right-hand hydraulic control lever: The right-hand
hydraulic control lever controls the bucket and the
boom or the dipper (depending on the control pat-
tern adopted).
NOTE: The operating speed depends on the angle
of movement of the control levers. In intermediate
position, two movements may be obtained simulta-
neously.
4. Stabilizer controls: The right-hand control is for the
right-hand stabilizer and the left-hand control is for
the left-hand stabilizer.
5. Control pattern change switch: This switch is used
for changing the standard control pattern to the ISO
pattern.
3 - CONTROLS/INSTRUMENTS
1
MOLI12LBB0178FB
6.
7.
8.
9.
10.
11.
3 - 62
Telescopic dipper controls: (proportional controls):
Press the right-hand button to extend the telescopic
dipper. Press the left-hand button to retract the tele-
scopic dipper.
Wrist rests: The wrist rests may be adjusted to the
required height.
Hydraulic control lever support angle adjustment:
These controls are used for the fore/aft and left/right
adjustment of the arm.
Horn button: (Momentary action control).
Controls of auxiliary bidirectional attachment (If fit-
ted): Proportional buttons for the activation of the
additional attachment.
Decelerator button: By pressing this button, the en-
gine rpm sets to low idle. During this phase, the
accelerator knob and pedal are disabled.
By pressing the button again, the engine rpm is re-
stored and the accelerator knob and pedal are func-
tional again.