Telescopic Dipper (Optional) - Adjustment Check - New Holland B95CTC Operator's Manual

7 - MAINTENANCE

Telescopic dipper (Optional) - Adjustment check

Move the machine to a level and firm ground
Lower the loader attachment to the ground.
Retract the telescopic dipper and place it on a support so
that the bucket does not rest on the ground.
Place the direction-of-travel lever and gearshift lever in
neutral position.
Immobilize the machine by means of the parking brake.
Stop the engine and remove the starter switch key.
The telescopic dipper is provided with adjustable wear
pads (4) and adjusted by removing shims (1) from under
the screws (2), located on both sides of the dipper.
Remove a shim from each screw on one side of the dipper.
NOTICE: each time a new adjustment is made, carry it out
on the other side of the dipper. If you are in any doubt
concerning adjustments, consult your Dealer.
Install and tighten the screws to a torque between 350 -
400 N·m (258 - 295 lb ft). Check the play again.
The play at point (3) should not exceed 1.5 mm (0.06 in).
When all adjusting shims have been removed the wear
pads (4) will require changing. Consult your Dealer.
1
LEEN12T0796BA
7 - 48