Lifting loads with the loader attachment
WARNING
Heavy object!
ALWAYS use adequate lifting equipment
(heavy-duty hoist, loader, or forklift) to lift the
component.
Failure to comply could result in death or se-
rious injury.
Loader bucket - with lifting ring
The lifting ring is the only point to which loads may be
attached on the loader bucket. The bucket must also be
in dumping position.
Loader bucket - without lifting ring
If the loader bucket is not supplied ex-works with a lifting
ring, consult your dealer.
Use the controls gradually so as to move the attachment
accurately.
The maximum authorized load must not exceed 1000 kg
(2205 lb).
Steady the load a few centimeters above the ground so it
is perfectly balanced before carrying out the lifting opera-
tion.
Do not allow any person within the machine's working
range.
When moving with a load, be sure to:
Keep the load as close as possible to the ground
•
and to the machine.
Always travel at low speed.
•
Operate the controls smoothly to obtain precise
•
movements and travel.
In order to reduce the load's oscillation, avoid sling-
•
ing it with too long ropes and/or chains.
Maximum
lifting
equipped) on loader bucket
ATTENTION: Do not exceed the maximum safe working
load for the loader.
Ensure you comply with local "lifting" regulations and, if in
any doubt, consult your dealer.
NOTICE: When using a 4 x 1 bucket with forks, make sure
that the bucket jaws are closed while lifting a load. Do not
attempt to open the bucket jaws with loaded forks.
The machine must be on a firm and level ground and the
forks must be in horizontal position.
6 - WORKING OPERATIONS
loads
with
forks
W0101A
(if
6 - 21
1
LEEN12T0660AA
2
LEEN12T0661AA