Bucket teeth - replacement
BUCKET - LOADER ATTACHMENT
Move the machine to a level and firm ground.
Position the loader bucket so that the bucket teeth can be
replaced.
Place the direction-of-travel lever and gearshift lever in
neutral position.
Immobilize the machine by means of the parking brake.
Stop the engine and remove the starter switch key.
Loosen and remove the screws (2) with the nuts (3).
Extract the tooth (1).
Clean the area around the tooth.
Assemble the new tooth (1).
Screw in and tighten the screws (2) with the nuts (3).
BUCKET - BACKHOE ATTACHMENT
Move the machine to a level and firm ground.
Position the backhoe bucket so that the bucket teeth can
be replaced.
Place the direction-of-travel lever and gearshift lever in
neutral position.
Immobilize the machine by means of the parking brake.
Stop the engine and remove the starter switch key.
Remove the safety pin (2) using a hammer and a punch or
tooth tool.
Extract the tooth (1).
Clean the area around the tooth holder.
Assemble the new tooth (1).
Install the safety pin (2).
7 - MAINTENANCE
7 - 100
1
LEEN12T0502AA
2
LEEN12T0695AA