Every 10 Hours; Checks At Start-Up And Before Each Workshift (10 Hours) - New Holland B95CTC Operator's Manual

Every 10 hours

Checks at start-up and before each workshift (10 hours)

MACHINE - GENERAL INSPECTION
Before using the machine, it is recommended to perform a
general inspection.
Externally check the machine and its working attachments,
checking for possible breaks or damage of the components
or the structure. Should problems be detected, contact an
authorized workshop to have the necessary repairs carried
out.
Replace the damaged or excessively worn parts with orig-
inal spare parts.
Keep the machine clean by daily removing the dirt accu-
mulated while working.
SERVICE BRAKE
Check the operation of the service (pedal) brakes on a hard
level surface after the first 100 hours of operation.
1. Make sure the area is clear of other workers or by-
standers.
2. Lock both pedals together with the brake pedal lock.
3. Shift the transmission to 2nd gear.
4. Drive the machine forward at full throttle.
5. When the machine is moving at full speed, remove
your foot from the throttle and stop the machine.
6. The machine must stop smoothly in a straight line
and the brake pedal effort must feel firm.
NOTICE: If the machine does not stop in a straight line or
if the brake pedal effort feels soft, contact your dealer for
service.
PARKING BRAKE
The parking brake is not serviceable. If a reduction of the
braking action is detected, contact the Service Department.
LIGHTS
Before using the machine, it is recommended to check that
all lights are clean and correctly operating.
FUNCTIONALITY OF CONTROLS AND LAMPS
Before using the machine, it is recommended to check that
all controls, instruments and lamps in the operator's com-
partment are correctly operating.
Should problems be detected, stop the engine and find the
cause of the anomaly.
7 - MAINTENANCE
7 - 14