Battery Removal And Installation - New Holland B95CTC Operator's Manual

Battery removal and installation

Move the machine to a level and firm ground.
Lower the loader attachment to the ground.
Place the backhoe attachment in the road travel position.
Place the direction-of-travel lever and gearshift lever in
neutral position.
Immobilize the machine by means of the parking brake.
Stop the engine and remove the starter switch key.
ATTENTION: Never reverse the battery terminals. Con-
nect the positive cable to the positive terminal (+) and the
negative cable to the negative terminal (-).
When disconnecting the battery cables, always disconnect
the negative cable (-) first.
When reconnecting the battery cables, always connect the
negative (-) cable last.
Never short-circuit the battery terminals with metal objects.
Never touch the battery terminals with your hands. This
could generate an electrolysis inside the human body and
damage the body's vital organs.
Place the battery switch in the OFF position.
NOTE: Wait at least 60 seconds after key off before turning
battery switch to the off position. This allows the machine
controllers to shutdown properly.
Remove the support (6) without disconnect the battery ca-
bles.
Remove the terminal covers and disconnect the cables,
first from the negative terminal (1) then the positive terminal
(2).
Remove the nuts and washers (3), the clamping bar (4) and
the brackets (5) and remove the old battery.
Install the new battery.
Install the brackets (5), the clamping bar (4) and the wash-
ers and nuts (3).
Clean the cables and the connecting terminals and coat
them with grease.
Connect the cables, first to the positive terminal (2), then
the negative terminal (1) and install the terminal covers.
Reassemble the battery master switch support (6).
7 - MAINTENANCE
7 - 98
1
LEEN12T0640AA
2
LEEN12T0694AA