Loader Bucket Control - 4X1 (If Fitted) - New Holland B95CTC Operator's Manual

Loader bucket control - 4x1 (If fitted)

This control operates the opening and closing of the 4 x 1
loader bucket clam.
This control is proportional:
When releasing the roller (7), it automatically returns to
the initial position (neutral) and the bucket remains in the
position where it was when movement stopped.
A. When shifting the roller (7) forward, the loader
bucket clam closes.
B. When shifting the roller (7) backward, the loader
bucket clam opens.
4 x 1 loader bucket control roller detent pro-
cedure
The operator may install a detent position for the 4 x 1
bucket operation.
This position alters operation in order to allow the operator
to lock the switch in the open circuit position, so that this
position is held until the operator unlocks the switch.
The standard position of the switch is with the open U
shape pointing upwards. In this configuration, the switch
will automatically spring back to the neutral position when
released, from any position.
To set the detent position to the bucket open position, it is
necessary to remove the top of the switch, rotating it by
180°.
Remove the screw (2) of the roller (1) using a small phillips
screwdriver.
Lift and remove the top portion (3) of the roller switch,
rotate it by 180° and tighten the screw in the top portion
of the roller.
NOTE: The open U shape must point downwards.
Carefully restore the screw (2) into place and do not over-
tighten.
Test the switch by lifting it up into detent position before
restoring the cap into place. The switch should lock into
position.
In this condition, the 4 x 1 loader bucket control roller is
locked. To unlock it, it is necessary to rotate the top por-
tion again and take it back to its initial position.
3 - CONTROLS/INSTRUMENTS
3 - 50
1
MOLI12LBB0164AB
2
MOLI12LBB0165AB
3
MOLI12LBB0166AB