MOVING THE UNIT
Job site travel
NOTE: The instruments represented may not exactly cor-
respond to the instruments on your machine
NOTE: After road travel, remove all road safety devices
before carrying out any job site travel.
Make sure that the engine accelerator knob (2) is in low
idle position.
Make sure the stabilizers are completely raised.
Make sure the doors are properly closed and that the en-
gine tilt hood is closed and locked.
Adjust the operator's seat correctly. Fasten the seat belt
(3) correctly and then adjust it.
Check that the direction of travel lever (4) is in neutral
position.
Start the engine.
Raise the loader attachment about 20 cm (7.9 in) off the
ground.
4 - OPERATING INSTRUCTIONS
4 - 10
1
LEEN12T0638AA
2
MOLI12LBB0209AB
3
MOLI12LBB0210AB