Backhoe Attachment Auxiliary Hydraulic Tools - New Holland B95CTC Operator's Manual

Backhoe attachment auxiliary hydraulic tools

Before using auxiliary tools (3), it is mandatory to proceed
as follows:
Check that the direction-of-travel control lever to neutral
position.
Place the gearshift lever in neutral position.
Lower the loader attachment to the ground.
Shut down the engine, release all pressure in the auxiliary
circuit, remove the plugs and connect the tool hoses to the
couplings (1) at the end of the boom.
NOTICE: Inverting the connections can cause involuntary
or untimely functioning of the tool or even damage it con-
siderably. To avoid all risk of accidents, follow the manu-
facturer's instructions carefully.
Flow selection
It is up to the operator to decide which flow should be used
by consulting the manufacturer's operating instructions.
Make sure to respect the prescribed delivery. Excess flow
can damage some equipment.
Place the accelerator knob/lever in full speed position.
Press down the control pedal (2) to operate the tool.
Release the control pedal (2) to stop the tool.
Depending on the flow requirement recommendations,
adjust the flow regulator on the chassis, at the rear of the
machine. Consult your Dealer.
10 - ACCESSORIES
10 - 3
1
LEEN12T0681BA_1
2
MOLI12LBB0510AA