Powershuttle Transmission - Screen Filter Cleaning - New Holland B95CTC Operator's Manual

Powershuttle transmission - screen filter cleaning

Move the machine to a level and firm ground.
Raise the loader attachment and install the safety support
strut.
Place the backhoe attachment in the road travel position.
Place the direction-of-travel lever and gearshift lever in
neutral position.
Immobilize the machine by means of the parking brake.
Stop the engine and remove the starter switch key.
Open and raise the engine tilt hood.
Place a container with suitable capacity under the screen
filter.
Clean the area around the cover plate (2).
Loosen and remove the screws (1).
Remove the cover plate (2), check the conditions of the
O-ring (3) and replace it, if necessary.
Remove the screen filter (4).
Clean the filter with a detergent solution.
NOTICE: follow the instructions for the detergent solution.
Carefully dry the screen filter (4) with compressed air and
reinstall it.
NOTICE: before using compressed air, take the necessary
precautions to protect your face.
Reassemble the cover plate (2) and fasten it by means of
the screws (1). Tighten the screws to a torque of 23 N·m
(16.96 lb ft).
Remove the dipstick (5) and top up the oil through the dip-
stick hole. Then restore the dipstick (5) into place.
Starting the engine.
Check the oil level by means of the dipstick and, if neces-
sary, add more oil.
Lower and lock the engine tilt hood.
Remove the safety support strut and lower the loader at-
tachment.
7 - MAINTENANCE
7 - 59
1
LEEN12T0685AA
2
LEEN12T0691AA
3
LEEN11T0356AA