Starter Motor - New Holland B95CTC Operator's Manual

Starter motor

PROBLEM
The starter motor does not run.
The starter motor running cannot
crank the engine.
Anomalous noise.
The pinion gear springs.
Field coil loss.
Magnetic switch coil burnt, etc.
8 - TROUBLESHOOTING
POSSIBLE CAUSE
Too low specific density and battery
level.
Poor ignition switch circuit connection
or contact.
Malfunction of the coil or of the
magnetic switch pull-in cylinder.
The pinion gear does not engage with
the ring gear.
Sliding clutch.
Anomalous bushing wear.
Wear on pinion gear or ring gear
tooth tips.
Poor pinion gear sliding.
Poor ignition switch return.
Pinion gear disengagement fault
caused by a coil short circuit in the
magnetic switch.
8 - 6
CORRECTION
Inspect the battery.
Replace the wiring harness and the
ignition switch or starter motor runs
too slowly.
Replace the magnetic switch.
Repair or replace the clutch and the
control lever.
Replace the clutch.
Replace starter.
For ring gear damage contact dealer.
Replace starter.
Replace the ignition switch.
Replace the magnetic switch.