Powershuttle transmission - oil filter replacement
Move the machine to a level and firm ground.
Raise the loader attachment and install the safety support
strut.
Place the backhoe attachment in the road travel position.
Place the direction-of-travel lever and gearshift lever in
neutral position.
Immobilize the machine by means of the parking brake.
Stop the engine and remove the starter switch key.
Open and raise the engine tilt hood.
Clean the area around the filter head.
Place a container with suitable capacity under the filter (1).
Loosen and remove the cartridge.
Apply a thin layer of oil on the new filter seal.
Assemble the new cartridge (1). Manually screw in the
cartridge until the seal touches the filter head.
Tighten by 2/3 of a turn.
NOTICE: overtightening can damage the filter seal.
Starting the engine
Remove the dipstick (2) and top up the oil through the dip-
stick hole. Then restore the dipstick (2) into place.
Check the oil level by means of the dipstick and, if neces-
sary, add more oil.
Lower and lock the engine tilt hood.
Remove the safety support strut and lower the loader at-
tachment.
7 - MAINTENANCE
7 - 57
1
LEEN12T0685AA
2
LEEN12T0688AA
3
LEEN11T0356AA