Front And Rear Axle - Oil Change - New Holland B95CTC Operator's Manual

Front and rear axle - oil change

Move the machine to a level and firm ground.
Lower the loader attachment to the ground.
Place the backhoe attachment in the road travel position.
Place the direction-of-travel lever and gearshift lever in
neutral position.
Immobilize the machine by means of the parking brake.
Stop the engine and remove the starter switch key.
DIFFERENTIAL OIL CHANGE - 4WD
Place a container with suitable capacity under the plug (1).
Unscrew and remove the plugs (1) and (2).
Wait for the oil to come out of the axle through the hole of
the plug (1).
After drain is complete, screw in the plug (1).
Fill with clean oil through the hole of the plug (2) until the
level reaches the hole.
Retighten the plug (2).
NOTE: Differential oil capacity . Refer to fluid supply sum-
mary table.
REDUCTION GEAR OIL CHANGE
Slightly raise the front part of the machine by means of the
loader attachment, until the front wheels are no longer in
contact with the ground and place a suitable support under
the front axle.
Manually position the wheel until the hole of the plug (1) is
in the lowest possible position.
Place a container with suitable capacity under the plug (1).
Unscrew and remove the plug (1).
Wait for the oil to come out of the reduction gear through
the hole of the plug (1).
7 - MAINTENANCE
7 - 62
1
LEEN12T0640AA
2
LEEN11T0375AA
3
LEEN11T0409AA_1