Engine oil level
Move the machine to a level and firm ground.
Raise the loader attachment and install the safety support
strut.
Place the backhoe attachment in the road travel position.
Place the direction-of-travel lever and gearshift lever in
neutral position.
Immobilize the machine by means of the parking brake.
Stop the engine, wait for it to cool down and remove the
starter switch key.
Release any possible residual pressure from the hydraulic
system by moving the control levers in all directions.
Open and raise the engine guard tilt hood.
Extract the dipstick (1), clean it with a clean cloth and com-
pletely insert it into the hose, then take it out again.
If the oil level is below the add mark, remove the filler cap
(2) and add oil up to the full mark on the dipstick.
Retighten the filler cap (2).
Lower and lock the engine tilt hood.
Remove the safety support strut and lower the loader at-
tachment.
7 - MAINTENANCE
7 - 17
1
LEEN12T0685AA
2
LEEN11T0356AA
3
LEEN11T0361AA