Hydraulic Oil System - Oil Filter Replacement - New Holland B95CTC Operator's Manual

Hydraulic oil system - oil filter replacement

Move the machine to a level and firm ground.
Lower the loader attachment to the ground.
Place the backhoe attachment in the road travel position.
Place the direction-of-travel lever and gearshift lever in
neutral position.
Immobilize the machine by means of the parking brake.
Stop the engine and remove the starter switch key.
Clean the area around the filter head, located in the bottom
left-hand part of the machine.
Place a container with suitable capacity under the filter.
Unscrew and remove the cartridge (1) by means of wrench
380000670.
Apply a thin layer of oil on the new filter seal.
Assemble the new cartridge (1).
Manually screw in the cartridge until the seal touches the
filter head.
By means of wrench 380000670, tighten by 3/4 of a turn.
NOTICE: overtightening can damage the filter seal.
Check that the oil level reaches the middle of the gauge
(2). Top up if necessary.
NOTICE: even when its level is insufficient, a small quantity
of hydraulic oil remains in the lower part of the gauge. This
does not mean that the level is sufficient.
7 - MAINTENANCE
7 - 65
1
LEEN12T0640AA
2
LEEN12T0473AA
3
LEEN12T0580AA