Engine Coolant - New Holland B95CTC Operator's Manual

Engine coolant

Move the machine to a level and firm ground.
Lower the loader attachment to the ground.
Place the backhoe attachment in the road travel position.
Place the direction-of-travel lever and gearshift lever in
neutral position.
Immobilize the machine by means of the parking brake.
Stop the engine and remove the starter switch key.
Wait for the machine to cool down.
Open and raise the engine tilt hood.
Check the level of fluid by directly checking the reservoir
(1).
The level in the coolant reservoir (1) must be between the
two marks.
If necessary, remove the cap (2) and add more coolant
solution.
NOTE: in order to reduce deposits and corrosion, coolant
in the cooling system should not exceed the following limits:
total hardness = 300 parts per million.
chloride = 100 parts per million.
sulphates = 100 parts per million.
ATTENTION: Scalding coolant solution can escape if the
coolant reservoir cap is removed while the system is still
hot. Allow the system to cool down completely before re-
moving the cap.
Lower and lock the engine tilt hood.
Remove the safety support strut and lower the loader at-
tachment.
7 - MAINTENANCE
7 - 20
1
LEEN12T0685AA
2
LEEN11T0357AA