Hand Hekl Auxiliary Hydraulic Tools - New Holland B95CTC Operator's Manual

10 - ACCESSORIES

Hand hekl auxiliary hydraulic tools

Before using hand hekl auxiliary tools, it is mandatory to
proceed as follows:
Check that the direction-of-travel control lever to neutral
position.
Apply the parking brake to prevent the machine from mov-
ing.
Place the gearshift lever to neutral.
Lower the loader attachment to the ground.
Place the hand hekl auxiliary hydraulic tool switch (1) in
the "OFF" position.
Stop the engine, remove the plugs and connect the tool
hoses to the couplings in front of the fuel tank. Coupling
(3) is for the hydraulic oil supply line and coupling (2) is
for the hydraulic oil return line.
NOTICE: Inverting the connections can cause involuntary
or untimely functioning of the tool or even damage it con-
siderably. To avoid all risk of accidents, follow the manu-
facturer's instructions carefully.
1
LEEN12T0682BA
Flow selection
The operator must determine the flow to be used by con-
sulting the tool manufacturer's operating instructions. Be
sure to select the flow specified. For some tool, an ex-
cessive flow can cause severe damage, therefore, it is
necessary to adjust the flow regulator on the chassis in
front of the axle. Consult your dealer.
Start the engine, place the accelerator knob/lever in full
speed position, then place the manual auxiliary hydraulic
tool switch (1) in the "ON" position (lamp on), now it is
possible to use the tool.
When the tool is no longer required, take the manual aux-
iliary hydraulic tool switch (1) back to the "OFF" position
2
MOLI12LBB0512AA
(lamp off).
10 - 4