Mechanical Backhoe Bucket Quick Coupler - New Holland B95C Original Instructions Manual

Mechanical backhoe bucket quick coupler

WARNING
Equipment failure could cause accident or injury!
Use only authorized auxiliary hydraulic attachments. Always read and understand the manual or in-
structions supplied by the manufacturer to avoid injury or damage. Understand the operation and
safety instructions before you attach, remove, or operate the attachment.
Failure to comply could result in death or serious injury.
WARNING
Crushing hazard!
Always use approved attachments. Make sure the attachment is compatible with the machine mount-
ing system.
Failure to comply could result in death or serious injury.
Removing an attachment with a mechanical quick coupler
1. Make sure that all unauthorized workers or bystanders
are away from the machine.
2. Park the machine on a level surface.
3. Lower the stabilizers to the ground.
4. Level the machine.
5. Roll the bucket outward.
6. Extend the boom and dipper.
NOTE: For easier access to the bucket pins later, prop
up the bucket pin side (3) on a suitable support de-
vice (4) capable of evenly supporting the weight of the
bucket. Make sure that the bucket pin side is higher
then the bucket teeth side.
7. Lower the backhoe until the bucket is just touching the
ground or support. Do not apply down force on the
bucket.
8. Turn off the engine and remove the key.
9. Insert the handle (2) into the mechanical coupler (1).
10. Pull the handle towards the bucket to release the top
of the quick coupler from the bucket.
11. Release and remove the handle from the quick cou-
pler.
NOTE: Store the handle in the tool box.
12. Start the engine.
13. Use the backhoe controls to rotate the quick coupler
out away from the lower bucket pin.
14. Make sure that you raise the stabilizers before mov-
ing the machine.
10 - ACCESSORIES
10-2
W0231A
W0183A
1
RAIL16TLB0537BA