Powershift Transmission - Oil Change - New Holland B95CTC Operator's Manual

Powershift transmission - oil change

Move the machine to a level and firm ground.
Raise the loader attachment and install the safety support
strut.
Place the backhoe attachment in the road travel position.
Place the direction-of-travel lever and gearshift lever in
neutral position.
Immobilize the machine by means of the parking brake.
Stop the engine and remove the starter switch key.
Open and raise the engine tilt hood.
Remove the dipstick (1).
NOTE: change the oil while the transmission is still warm;
the oil will flow more easily.
Place a container with suitable capacity under the drain
plug (2).
Loosen and remove the drain plug (2).
Let the transmission oil drain.
Install the drain plug (2).
Fill with new oil of specified type through the dipstick hole.
NOTE: Transmission oil capacity . Refer to fluid supply
summary table.
Reinstall the dipstick (1).
Check the oil level by means of the dipstick and, if neces-
sary, add more oil.
Drive the machine for a few minutes in first and second
gear, then stop the machine with engine run and transmis-
sion in neutral gear.
Apply the parking brake.
Check the oil level by means of the dipstick and, if neces-
sary, add more oil.
Lower and lock the engine tilt hood.
Remove the safety support strut and lower the loader at-
tachment.
7 - MAINTENANCE
7 - 61
1
LEEN12T0685AA
2
LEEN11T0356AA
3
LEEN11T0408AA_1