Loader bucket Removal
B95C - B95CLR - B110C
Move the machine to a level and firm ground.
Lower the bucket to the ground in dump position (tilted
completely forward).
Stop the engine and remove the starter switch key.
If the machine is fitted with a 4x1 bucket, release the pres-
sure from the bucket circuit.
Remove the fastening screws, then remove the pins (1).
ATTENTION: Always wear eye protection when using a
tool which might project metal particles. Use a hammer
with a soft face, such as copper, for pins assembly/disas-
sembly.
(4x1 bucket) disconnect and plug the hydraulic supply
lines.
Start the engine.
Operate the attachment controls so as to release the
bucket.
Reverse the machine from the bucket.
B95CTC
Move the machine to a level and firm ground.
Lower the bucket to the ground in dump position (tilted
completely forward).
Stop the engine and remove the starter switch key.
If the machine is fitted with a 4x1 bucket, release the pres-
sure from the bucket circuit.
Remove the retaining rings and pins, then drive out the
pins (1).
ATTENTION: Always wear eye protection when using a
tool which might project metal particles. Use a hammer
with a soft face, such as copper, for pins assembly/disas-
sembly.
(4x1 bucket) disconnect and plug the hydraulic supply
lines.
Start the engine.
Operate the attachment controls so as to release the
bucket.
Reverse the machine from the bucket.
6 - WORKING OPERATIONS
6 - 15
1
MOLI12LBB0267AB
2
MOLI12LBB0270AB