Starter Motor - Troubleshooting - New Holland B95C Original Instructions Manual

Starter motor - Troubleshooting

Problem
The starter motor does
not run.
The starter motor running
cannot crank the engine.
Anomalous noise.
The pinion gear springs.
Field coil loss. Magnetic
switch coil burnt, etc.
8 - TROUBLESHOOTING
Possible Cause
Too low specific density and battery level. Inspect the battery.
Poor ignition switch circuit connection or
contact.
Malfunction of the coil or of the magnetic
switch pull-in cylinder.
The pinion gear does not engage with the
ring gear.
Sliding clutch.
Anomalous bushing wear.
Wear on pinion gear or ring gear tooth tips. For ring gear damage contact dealer.
Poor pinion gear sliding.
Poor ignition switch return.
Pinion gear disengagement fault caused by
a coil short circuit in the magnetic switch.
Replace the wiring harness and the ignition
switch or starter motor runs too slowly.
Replace the magnetic switch.
Repair or replace the clutch and the control
lever.
Replace the clutch.
Replace starter.
Replace starter.
Replace the ignition switch.
Replace the magnetic switch.
8-5
Correction