Power Shuttle Transmission - Oil Filter Replacement - New Holland B95C Original Instructions Manual

Power shuttle transmission - Oil filter replacement

1. Move the machine to a level and firm surface.
2. Raise the loader attachment and install the safety sup-
port strut.
3. Place the backhoe attachment in the road travel posi-
tion.
4. Place the direction-of-travel lever and gearshift lever in
the neutral position.
5. Engage the parking brake.
6. Stop the engine and remove the starter switch key.
7. Release any possible residual pressure from the hy-
draulic system by moving the control levers in all direc-
tions.
8. Unlock, open and raise the engine hood.
9. Clean the area around the transmission oil filter and
filter head (1).
10. Place a container with suitable capacity under the filter
(1).
11. Loosen and remove the filter.
12. Apply a thin layer of oil on the new filter seal.
13. Install the new filter (1) and tighten it by hand until the
seal touches the filter head.
14. Tighten the filter an additional 2/3 of a turn.
NOTICE: Overtightening can damage the filter seal.
15. Start the engine and run the machine with the parking
brake engaged and the direction-of-travel lever and
gearshift lever in the neutral position.
16. Remove the dipstick (2).
17. Check the oil level, and add additional oil if necessary.
18. Lower and lock the engine hood.
19. Remove the safety support strut and lower the loader
attachment.
Oil specification and capacities
Use H T
YDRAULIC RANSMISSION
Capacities: 2WD Total System 18.5 L (19.5 US qt), Re-
fill with or without filter change 11.9 L (12.6 US qt).
Capacities: 4WD Total System 20.8 L (22.0 US qt), Re-
fill with or without filter change 14.4 L (15.2 US qt).
7 - MAINTENANCE
O - P .
IL REMIUM
7-102
1
LEEN12T0688AA
2
LEEN11T0356AA