Power Shuttle Transmission - Screen Filter Cleaning - New Holland B95C Original Instructions Manual

Power shuttle transmission - Screen filter cleaning

1. Move the machine to a level and firm surface.
2. Raise the loader attachment and install the safety sup-
port strut.
3. Place the backhoe attachment in the road travel posi-
tion.
4. Place the direction-of-travel lever and gearshift lever in
the neutral position.
5. Engage the parking brake.
6. Stop the engine and remove the starter switch key.
7. Release any possible residual pressure from the hy-
draulic system by moving the control levers in all direc-
tions.
8. Unlock, open and raise the engine hood.
9. Place a container with suitable capacity under the
screen filter.
10. Clean the area around the cover plate (2).
11. Loosen and remove the screws (1).
12. Remove the cover plate (2), check the conditions of
the O-ring (3) and replace it, if necessary.
13. Remove the screen filter (4).
14. Clean the screen filter with a detergent solution.
NOTICE: Follow the instructions for the detergent solution.
CAUTION
15.
Flying debris!
Compressed air can propel dirt, rust, etc. into
the air. Wear eye and face protection when
using compressed air.
Failure to comply could result in minor or mod-
erate injury.
Carefully dry the screen filter (4) with compressed air
and reinstall it.
16. Reassemble the cover plate (2) and fasten it by means
of the screws (1). Tighten the screws to a torque of
23 N·m (16.96 lb ft).
17. Remove the dipstick (5) and top up the oil through the
dipstick hole. Then restore the dipstick (5) into place.
18. Start the engine and check for oil leaks.
19. Check the oil level by means of the dipstick and add
additional oil if necessary.
20. Lower and lock the engine hood.
21. Remove the safety support strut and lower the loader
attachment.
7 - MAINTENANCE
C0049A
7-103
1
LEEN12T0691AA
2
LEEN11T0356AA