Telescopic Dipper - New Holland B95C Original Instructions Manual

Telescopic dipper

The telescopic dipper is equipped with adjustable wear
pads (4). Adjust the wear pads as follows:
1. Move the machine to a level and firm surface.
2. Lower the loader attachment to the ground.
3. Retract the telescopic dipper and place it on a support
so that the bucket does not rest on the ground.
4. Place the direction-of-travel lever and gearshift lever in
neutral position.
5. Engage the parking brake.
6. Stop the engine and remove the starter switch key.
7. Remove a shim (1) from each bolt (2) on only one side
of the dipper.
NOTE: The shims (1) are available under the bolts (2) on
both the sides of the dipper
NOTICE: Remove the shim ONLY from the other side of
the dipper where shims were removed during the previous
adjustment procedure. Contact your dealer, if you are in
doubt.
8. Install and torque the bolts (2) to a torque between 350
– 400 N·m (258 – 295 lb ft). Check the play again.
9. The play at point (3) should not exceed 1.5 mm
(0.06 in).
10. When all adjusting shims have been removed the
wear pads (4) will require changing. Consult your
Dealer.
7 - MAINTENANCE
7-77
1
LEEN12T0796BA