Table of Contents
Advertisement
5) Tighten new bolts (1) until head of each bolt is broken off.
6) Turn ignition key to "ACC" or "ON" position and check to be
sure that steering shaft (2) rotates smoothly. Also check for
lock operation.
7) Install steering column. Refer to "STEERING COLUMN".
STEERING LOWER SHAFT
CAUTION:
Never turn steering wheel while steering lower shaft is
removed.
Should it have been turned and contact coil (on combina-
tion switch) have got out of its centered position, it needs
to be centered again. Also, turning steering wheel more
than about two and a half turns will break contact coil.
REMOVAL
1) Turn steering wheel so that vehicle's front tires are at
straight-ahead position.
2) Turn ignition switch to "LOCK" position and remove key.
3) Remove steering joint cover (5).
4) Make alignment marks (4) on lower shaft (1) and shaft joint
of steering column (2) and lower shaft (1) and pinion shaft
(3) for a guide during reinstallation.
5) Remove lower shaft joint bolts (6).
6) Remove steering lower shaft (1).
STEERING WHEEL AND COLUMN 3C-17
Advertisement
Table of Contents
