Table of Contents
Advertisement
INSTALLATION
1) Check that vehicle's front tires are at straight-ahead position
and contact coil is centered. Refer to "CENTERING CON-
TACT COIL".
CAUTION:
These two conditions are prerequisite for installation of
steering wheel. If steering wheel has been installed with-
out these conditions, contact coil will break when steer-
ing wheel is turned.
2) Install steering wheel (1) to steering shaft with 2 lugs (2) on
contact coil fitted in two grooves (3) in the back of steering
wheel and also aligning marks (4) on steering wheel and
steering shaft.
3) Tighten steering shaft nut (1) to specified torque.
Tightening torque
Steering shaft nut (a) : 33 N·m (3.3 kg-m, 24.0 lb-ft)
NOTE:
After installing the steering wheel, turn the steering
wheel about 1 full rotation so that the cancel cam pin fits
into the pin hole in the steering wheel and then check the
turn signal lever for proper function.
4) Install driver air bag (inflator) module to steering wheel.
Refer to "DRIVER AIR BAG (INFLATOR) MODULE".
CENTERING CONTACT COIL
1) Check that vehicle's wheels (front tires) are set at straight-
ahead position.
2) Check that ignition switch is at "LOCK" position.
3) Turn contact coil counterclockwise slowly with a light force till
contact coil will not turn any further.
NOTE:
Contact coil can turn about 5 turns at maximum, that is, if
it is at the center position, can turn about two and a half
turns both clockwise and counterclockwise.
STEERING WHEEL AND COLUMN 3C-7
Advertisement
Table of Contents
