DTC P2127
DTC P2127
APP sensor No.2 circuit low input
DETECTION
CONDITION
POSSIBLE
CAUSE
The PCM monitors the input voltage from the APP sensor No.2 when the engine
•
is running. If the input voltage is less than 0.3 V , the PCM determines that the
APP sensor No.2 circuit input voltage is low.
Diagnostic support note
This is a continuous monitor (CCM).
•
The MIL illuminates if the PCM detects the above malfunction condition in the
•
first drive cycle.
PENDING CODE is available if the PCM detects the above malfunction
•
condition.
FREEZE FRAME DATA is available.
•
The DTC is stored in the PCM memory.
•
APP sensor No.2 malfunction
•
Connector or terminal malfunction
•
Open circuit in wiring harness between APP sensor terminal A and PCM terminal
•
4X
Short to GND in wiring harness between APP sensor terminal A and PCM
•
terminal 4X
Open circuit in wiring harness between APP sensor terminal C and PCM terminal
•
5C
Short to GND in wiring harness between APP sensor terminal C and PCM
•
terminal 5C
PCM malfunction
•
(w)
Engine Diagnostics & Control
Page 379