Mazda RX-8 Manual page 852

Diagnostic procedure
STEP INSPECTION
VERIFY FREEZE FRAME DATA HAS
BEEN RECORDED
1
Has FREEZE FRAME DATA been
•
recorded?
VERIFY RELATED REPAIR
INFORMATION AVAILABILITY
Verify related Service Bulletins and/or
•
2
on-line repair information availability.
Is any related repair information
•
available?
VERIFY STORED DTC IN KEYLESS
CONTROL MODULE
Turn the ignition switch to the ON
•
position (Engine off).
Verify stored DTCs in keyless control
•
3
module.
(See DTC INSPECTION
(IMMOBILIZER SYSTEM) .)
Are DTCs stored ?
•
VERIFY TROUBLESHOOTING OF DTC
P1260 COMPLETED
Make sure to reconnect all disconnected
•
connectors.
4
Clear the DTC from the PCM memory
•
using the WDS or equivalent.
Start the engine.
•
Is the same DTC present?
•
5 VERIFY AFTER REPAIR PROCEDURE
ACTION
Yes Go to the next step.
Record the FREEZE FRAME DATA on the
No
repair order, then go to the next step.
Perform repair or diagnosis according to the
available repair information.
Yes
If the vehicle is not repaired, go to the next
•
step.
No Go to the next step.
Go to the appropriate DTC inspection.
Yes
(See DTC TABLE (IMMOBILIZER SYSTEM) .)
No Go to the next step.
Replace the PCM, then go to the next step.
Yes
(See PCM REMOVAL/INSTALLATION .)
No Go to the next step.
Go to the applicable DTC inspection.
Yes
(See DTC TABLE .)
(w) Engine Diagnostics & Control
Page 289