Avaya Definity SI Maintenance Manual page 2015

PI-BD (Processor Interface Circuit Pack)
Table 10-459. TEST #423 Standby PI Board Test — Continued
Error
Code Result
16 FAIL
80
94
102
23 FAIL
199
9000s FAIL
PASS
555-233-123
Test
Internal system error
1. Retry the command at 1-minute intervals a maximum of 5
times.
2. If problem still exists, redownload firmware using the reset
interface command.
Download of Processor Interface firmware failed.
1. Wait 1 minute and retry. A tape access problem could be
present. Check that tape is in tape drive.
2. If the problem persists and Standby TAPE is idle when
command is entered, then a problem could exist in either the
Standby TAPE or the Processor Interface circuit pack.
Replace the tape with a new tape that contains Processor
Interface firmware. Retry the command.
3. If the problem still exists, then refer to the TAPE Maintenance
documentation for possible TAPE errors. If there are no TAPE
errors, repeat the test command up to 5 times. If problem still
exists, replace the TN765 circuit pack. Refer to
''Reliability Systems: A Maintenance Aid''
how to replace an SPE complex circuit pack.
4. If problem still exists with new TN765 Processor Interface
circuit pack, replace TAPE drive.
Processor Interface Download failed.
1. Refer to TABLE A, Tape Unit Data Table, and follow the repair
recommendations.
TN765 Processor Interface circuit pack initialized correctly.
Processor Interface links (X.25 and ISDN) should recover now.
See "PI-LINK" for more information if links do not recover.
Description/Recommendation
Continued on next page
Issue 4 May 2002
Chapter 6,
for instructions on
10-1229