Fixing The Ups - Delta Modulon DPH Series User Manual

The casters are designed to move on level ground. Do not move the UPS on an uneven
surface. This might cause damage to the casters or tip the UPS, which could damage
the unit.
After the UPS has been removed from the pallet to ground, we suggest that at least
three people move the UPS to the installation area. One person use their hands to hold
a lateral side of the UPS, one person hold the other lateral side of the UPS with their
hands, and one person use their hands to push the UPS either from the front side or
from the backside to move the unit to the installation area and avoid tipping the UPS.
If you need to move the UPS over a long distance, please use appropriate equipment
like a forklift. Do not use the UPS casters to move the unit over a long distance.
5.4

Fixing the UPS

Please follow the steps below:
1
information, please refer to Table 5-1.
2
After the UPS is moved to the designated installation area, use a #17 wrench to
3
Use a 17mm socket wrench and three M10 screws
balance support on the pallet) to install the front balance support (removed during the
unpacking process) at the front of the UPS. Use the three expansion screws & nuts
2
avoid UPS movement. Please see Figure 5-2.
Modulon DPH Series
1
M10 Screw
X 3
(Figure 5-2: Install the Balance Support at the Front of the UPS)
1
(Front View)
Expansion Screw
& Nut X 3
5-4
2
Balance
Support
Ground