Ups Transportation & Handling; Ups Installation & Fixing - Delta HPH-60K User Manual

6.3 UPS Transportation & Handling
There are four casters at the bottom of the UPS. Please pay attention to the movement of
the casters to avoid accidents when you remove the UPS from its pallet. The casters are
designed to move on level ground. Do not move the UPS on an uneven surface. This might
cause damage to the casters or tip the UPS which could damage the unit. If you need to
move the UPS over a long distance, please use appropriate equipment like a forklift. Do not
use the UPS casters to move the unit over a long distance.
6.4 UPS Installation & Fixing
NOTE:
kVA model. In this chapter, only 60/ 80kVA model is used to illustrate the installation
on the ground.
2. There are two installation methods. One is with the balance supports, and the other is
without the balance supports. Please refer to the following.
Installation without the Balance Supports
After you decide the installation area, follow Figure 6-2 to drill holes on the installation
ground. M10 screws with length above 95mm are required.
(Figure 6-1: Stabilize the UPS with Levelers)
29
Chapter 6 Installation and Wiring