Fixing The Ups - Delta Ultron DPM Series User Manual

5.3

Fixing the UPS

1
The UPS system cabinet and power modules must be installed side by side. Before
fixing the UPS system cabinet and power modules in a designated area, please
Please refer to Table 5-1.
2
There is a knockout panel at each side of the UPS system cabinet. Please see Figure
5-2. Remove the knockout panels, take out the snap bushings from the package
bag, and install the snap bushings on the locations where you removed the knockout
panels.
The locations where you remove the knockout panels are the places that you can
route the two provided D-SUB15 communication cables to connect the UPS system
cabinet and the power modules.
Before shipment, the two provided D-SUB15 communication cables have already been
attached to the CNPF411A port and CNPF410 port located at the power modules' PF4
power boards as shown in Figure 5-13. For more information, please refer to
Knockout Panel
(Left-hand Side)
(Figure 5-2: Location of the UPS System Cabinet's Knockout Panels)
1000/ 1250kW
(UPS System Cabinet)
POWE EMER GENC
Don't R OFF Y
emergen cy! operate unless in
5-5
5 Installation and Wiring
6
.
Knockout Panel
(Right-hand Side)