Fixing The Ups - Delta Modulon DPH series User Manual

The casters are designed to move on level ground. Do not move the UPS on an uneven
surface. This might cause damage to the casters or tip the UPS which could damage
the unit.
After the UPS has been removed from the pallet to the ground, we suggest that at least
three people move the UPS to the installation area. With their two hands, one person
holds a lateral side of the UPS, another person holds the other lateral side of the UPS,
and the other person pushes the UPS, either from the front side or from the backside,
to move the unit to the installation area. This is the best way to avoid tipping the UPS.
If you need to move the UPS over a long distance, please use appropriate equipment
(e.g. forklift). Do not use the UPS casters to move the unit over a long distance.
5.4

Fixing the UPS

NOTE:
When handling or moving the UPS, please use appropriate equipment (e.g. forklift).
Please follow the steps below:
1
information, please refer to Table 5-1.
2
After the UPS is moved to the designated installation area, use a #17 wrench to
3
Use six M10 screws (three for the front, three for the rear)
and nuts (three for the front, three for the rear)
balance supports. Please refer to Figure 5-3 ~ Figure 5-4. The six M10 screws and the
two balance supports are those been taken apart from the UPS earlier while moving
the UPS from the pallet to the ground (see 5.3 UPS Transportation). As for the six
WARNING:
1. The UPS is fixed on the pallet with two balance supports and six M10
screws. When taking apart the two balance supports from the UPS, pay
attention to the movement of the casters to avoid accidents.
2. Please refer to the Unpacking Guide attached to the UPS external
wooden box for the location of the balance supports.
WARNING:
You must stabilize the UPS with the two provided balance supports.
Otherwise, the UPS might tip over.
2
5-5
5 Installation and Wiring
and six expansion screws
1