Henny Penny 500 Service Manual page 97

el 61
PLATE
MOSTAT
r-nmrcmt
ACC'W
I
THERM~AT
POT FITTING
SCREW NUT
7. With the door of the fryer closed, put the bottom
edge of the control panel in the slot between the
door and the frame of the fryer.
8. Locate the thermostat on the back of the panel.
9. Remove the thermostat knob on the front of the
control panel.
10. move the two screws which secure the thermo-
stat to the back of the panel. emove the thermo-
stat bezel.
11. emove the small inside screw nut which holds the
capillary line.
emove the thermostat pot fitting.
13. Label the wire connections to the thermostat for
correct identification when the new thermostat is
installed.
14.
isconnect the wires.
move the defective thermostat.
nstall the new thermostat.