Henny Penny 500 Service Manual page 144

It may be necessary to remove knobs and change their
position in order to align the red knob with the red
knob on the lid cover lid latch.
When in the normal
gr
V
operating position, both red knobs should be aligned.
5. Adjust the limit stop by turning it counterclockwise
until it stops against the bottom hub of the spindle.
6. Tighten allen set screws.
id Cover fails to seal properly, steam will
escape around the gasket during the frying opera-
tion. The limit stop should be readjusted. This time
turn the spindle screw one full turn aRer the initial
contact of the lid gasket against top of the frypot
rim.
This assembly is used to tighten the lid cover against
the frypot flange.
1. Loosen the set screw in the limit stop collar and
loosen the limit stop.
r@g,
,,: p,'::, ,:
>
"*':,';;;e
2. isengage the crossbar from the lid cover as de-
scribed in the "Lid Cover Removal". Leave the lid
cover in position on the frypot rim with the crossbar
in the upright position.
3. Turn the spindle so the pin in the locking collar will
be exposed.
.
move pin and locking collar.
se a small diame-
unch and a hammer to drive out the pin from
the locking collar.
move the locking collar.