Henny Penny 500 Service Manual page 127

6. Attach wires to the
TI
labels attached.
in accordance with the
nstall control panel per paragraph 5-4.
Some models of the fryer utilize the following QP-
TIONAL EQUIPMENT - ELAY TIMER, DUAL IN-
DICATING THERMOSTAT, or TWO STAGE THER-
MOSTAT, and a SOFT/CRISP switch. To replace any-
one of these items the following instructions are
provided.
efore starting this procedure, move MAIN
POWER switch to the OFF position. Disconnect
main circuit breaker at the circuit breaker box
and/or unplug service cord at the wall receptacle,
or electrical shock could result.
See paragraph 5-10 step 7.
1. emove control panel per paragraph 5-4.
2. Label and disconnect each wire connected to the
ELAY TIMER.
move the two screws and nuts securing the
timer to the panel.
ELAY TIME from the control
panel, do not attempt repair.
5. Install the new DELAY TIME on the rear of
the control panel.
6. Secure the timer with the two screws and nuts.
7. Connect the labeled wires to the
nals of the new timer.
er termi-
e ~~ntrol panel ara